You love your carpets, but sometimes they need a little bit of extra attention and love. If it’s due to spills or general wear and tear, sometimes your carpets will need to be cleaned by hand. However, don’t fret you don’t have to be as complicated as it sounds! Here’s a step-by step guide for hand-washing your carpets.

Pet urine can be a issue and will require Carpet Cleaning in Waubeka! It can create odors and spread disease. However, My Steam Green Carpet Cleaning in Waubeka can help you get your carpets clean cleaning, once and for all! Call us now!

Step One: Prep the Area

Start by clearing everything from the room you can. It’s not just furniture as well as knick-knacks and carpets and rugs that aren’t being washed. If you can, open any windows in the room to let in sunlight and fresh air. Once the area is clear then make sure to give your carpets a good vacuum. Be sure to pay particular focus on areas that are frequented by people and any areas where there might be dried-on dirt or debris. If you have the time let the carpet air out for 30 minutes prior to starting cleaning it.

Step Two: Mix Your Solution

In a bowl or bucket, mix together the white vinegar of one cup and 1 cup warm water. Stir until all the ingredients are blended.

Step Three: Spot Test

Before you apply the solution to the entire carpet, it’s important to test the solution in an inconspicuous area first. This will help you make it certain the product won’t cause damage to your carpet or fade it or alter the color of your carpet in any manner. For a spot-test take a small amount of the solution onto a clean cloth and rub it into the carpet. Let the solution sit for five minutes prior to moving into the next stage.

Step Four: Wash the Carpet

After you’ve confirmed your carpet that you’re not going to cause damage to your carpet, begin cleaning! With a clean cloth or sponge, apply the solution to small sections of the carpet, working from top to bottom. Apply the solution in gentle circular motions. avoid scrubbing too hard–you don’t want to scratch the fibers of your carpet! When you’re cleaning, pay special focus on heavily soiled areas. If you need to, use a brush with soft bristles to get stubborn dirt from these areas. Just be sure not to scrub too hard, as you don’t want to damage the carpet’s fibers!

Step Five: Rinse and Repeat

Once you’ve cleaned all carpets with the cleaning solution, now is the time to rinse it off with clean water. With a clean sponge or cloth use fresh water on small areas of the carpet and then blot dry. Work from top to bottom and be careful not to scrub too hard; you don’t want to damage delicate carpet fibers! Repeat this procedure until all trace of the cleaning solution are gone of the carpet.

How much is it to carpet a boat in Waubeka?